Driver Anatel Modem Pci Slot

I am attempting to install a PCI to USB card made by pcally and it is supposed to be a true plug and play device with no driver required. I place the card into a PCI slot, and start the computer. Windows begins loading, but the computer restarts part way through the loading process. The next time windows attempts to load, a screen comes up that reports that windows could not load properly last time and gives me several options, including run windows normally, run in safe mode, command prompt only, etc. I choose normal, and windows starts up, but in 16 color mode. Before any of the icons appear on the desktop, a text box pops up and says 'There is a problem with your display setting. The adaptor type is incorrect, or the current settings do not work with your hardware.' I press the OK button, and the Display Properties screen comes up. I press the Cancel button, and go into Control Panel -> Settings, and choose the Device Manager tab. Under the Universal Serial Bus controllers heading, the PCI card appears as Opti 82C8… PCI to USB Open Host Controller, and has a yellow circle with an exclamation mark in it. I double click on this. In the Device Status box, it says that the NTKERN.VXD device loader(s) could not load the device driver. It says to fix the problem, I should click the Update Driver button. I do this, and the Update Device Driver Wizard starts up. I eventually get to a point where it tells me that I am already using the best driver, but I can reinstall the driver. I choose to reinstall the driver. It says that the location of the driver is C:WINDOWSINFUSB.INF. I click next, and it tells me that it could not find device at that location and asks me to insert the Windows 98 SE CD-ROM. I do this, and it tell me that the file 'openhci.sys' could not be found on the CD, and asks me to insert the same CD again. I click the Skip File button, and the same process happens twice more for the files 'usbd.sys' and 'usbui.sys'. I skip through both these files, and it tells me it has finished reinstalling the driver. It then asks me to restart so the new hardware can take effect, so I restart, and the machine starts up again in 16 color mode. When I look at the Devices Manager List again, the PCI to USB Open Host controller still has the exclamation mark. I was later able to find the files 'usbd.sys' and 'usbui.sys' already on my computer, so I repeated the process and pointed the wizard to these locations when it said it could not find these files on the Windows 98 SE CD. However, I could not find the file 'openhci.sys'. I restarted, but the computer only runs in 16b color mode again, and there is still the exclamation mark on the PCI to USB controller in the Devices Manager. I also checked under the Resources tab when looking at the information about the PCI to USB controller and it reports no conflicts. Thank you for reading and for any help you may be able to offer.